1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. annieebanana
    Post

    Answered Layer View in Mattercontrol has odd symbol?

    Also, it seems like this file is skipping some layers in the perimeter...like every so often there will be 3 layers of support material where the...
    Post by: annieebanana, Dec 10, 2017 in forum: Troubleshooting
  2. annieebanana
    Thread

    Answered Layer View in Mattercontrol has odd symbol?

    Hi again friends, I am preparing a print but when viewing in layer view, I see this odd symbol that is like a little red circle or stop sign??...
    Thread by: annieebanana, Dec 10, 2017, 3 replies, in forum: Troubleshooting
  3. annieebanana
    Post

    Solved MatterControl Crashed but printer is continuing...can I let it run? (16hrs into a 30 hr print)

    Thanks friends! The print finished fine and I have since run two more with the same laptop setup. I am using these prints for a school project...
    Post by: annieebanana, Dec 10, 2017 in forum: Troubleshooting
  4. annieebanana
    Post

    Solved MatterControl Crashed but printer is continuing...can I let it run? (16hrs into a 30 hr print)

    Thanks Geof! The printer is still running right now and it seems fine...I'll just let it go and we'll see what happens. I tried to load from an SD...
    Post by: annieebanana, Dec 6, 2017 in forum: Troubleshooting
  5. annieebanana
    Thread

    Solved MatterControl Crashed but printer is continuing...can I let it run? (16hrs into a 30 hr print)

    Hi, I'm pretty noob and this is my first long print...previous longest was 5 hours. Now I am 16 hours into a 30 hours print, running matter...
    Thread by: annieebanana, Dec 6, 2017, 7 replies, in forum: Troubleshooting
Showing results 1 to 5 of 5
Search Again