1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Solidur
    Post

    Solved X axis movement problem

    Fixed it thanks for all the help Mark, its working as intended now.
    Post by: Solidur, Dec 14, 2017 in forum: Troubleshooting
  2. Solidur
    Post

    Solved X axis movement problem

    Yes I was able to trace each switch wire back to the board and make sure they are properly placed and attached. I also rechecked my Y and Z...
    Post by: Solidur, Dec 14, 2017 in forum: Troubleshooting
  3. Solidur
    Post

    Solved X axis movement problem

    I disconnected the wires from the RAMPS and ran it again it still said TRIGGERED... any way to check the board vs the firmware?
    Post by: Solidur, Dec 14, 2017 in forum: Troubleshooting
  4. Solidur
    Post

    Solved X axis movement problem

    Sorry for the delayed response but I didn't have any free time to check the switch yesterday. I just disconnected the wires from the switch...
    Post by: Solidur, Dec 14, 2017 in forum: Troubleshooting
  5. Solidur
    Post

    Solved X axis movement problem

    Ok thanks for the link and info I had tried to disconnect the wiring from the switch itself earlier today and if I remember correctly it still...
    Post by: Solidur, Dec 12, 2017 in forum: Troubleshooting
  6. Solidur
    Post

    Solved X axis movement problem

    I watched the video but it did not explain my issue. I am having an X axis issue and from watching some other videos I was able to figure out my...
    Post by: Solidur, Dec 12, 2017 in forum: Troubleshooting
  7. Solidur
    Thread

    Solved X axis movement problem

    I just received a Robo 3D R1 or R1+ not sure which or what the difference is but when trying to use the G29 code prior to printing the X Axis...
    Thread by: Solidur, Dec 12, 2017, 13 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again