1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Jake Ciasca
    Thread

    Unresolved PETG warping issue

    So I recently got a batch of hatchbox petg and I adjusted some of my print settings like temperature both bed and nozzle and basic stuff that...
    Thread by: Jake Ciasca, Feb 8, 2021, 14 replies, in forum: Troubleshooting
  2. Jake Ciasca
    Thread

    Solved Error in Arduino

    I'm getting an error in arduino trying to compile the firmware to the board and I have no idea what it means or how to fix it, does anybody know?...
    Thread by: Jake Ciasca, Jul 4, 2020, 7 replies, in forum: Troubleshooting
  3. Jake Ciasca
    Thread

    Unresolved Weird Layer Discrepancies

    I messed around with the flow in the slicer i used changing it from 95% to 100% to 105% and finally 110% thinking this was an under extrusion...
    Thread by: Jake Ciasca, Jul 3, 2020, 6 replies, in forum: Troubleshooting
  4. Jake Ciasca
    Thread

    Solved Bed tries to move farther than it can

    The bed of my printer seems to be trying to move farther than it can move and I'm not sure if I have to change the g-code or settings in the...
    Thread by: Jake Ciasca, Jul 3, 2020, 6 replies, in forum: Troubleshooting
  5. Jake Ciasca
    Thread

    Answered Temp Fall Error Fix?

    This issue has been happening more and more and I'm not sure why, I recently installed an E3D V6 hotend and it was working for a little bit and...
    Thread by: Jake Ciasca, Feb 1, 2020, 1 replies, in forum: Troubleshooting
  6. Jake Ciasca
    Thread

    Solved Extruder Calibration and Esteps

    So I was calibrating my new E3D V6 hotend following this video, [MEDIA] by Tom and I changed the value in the arduino code for the printer to...
    Thread by: Jake Ciasca, Jul 3, 2019, 14 replies, in forum: Troubleshooting
  7. Jake Ciasca
    Thread

    Partially Solved Extruder not pulling filament with new E3D V6 hotend

    So I just got around to installing my E3D hotend, I drilled out the extruder hole for the ptfe tubing and everything is fine, the only problem is,...
    Thread by: Jake Ciasca, Jul 1, 2019, 13 replies, in forum: Troubleshooting
  8. Jake Ciasca
    Thread

    Solved Robo 3d R1 Plus LCD isn't working

    So for christmas I got an lcd controller for the printer so I hooked all the wires up, got arduino downloaded, got marlin downloaded, got the...
    Thread by: Jake Ciasca, Dec 31, 2017, 17 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again