1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Pierce
    Post

    Answered First Layer Extrusion

    Solution worked well, could it be that when I updated matter control the changes were reset to default? That was when I noticed the errors.
    Post by: Pierce, Apr 17, 2018 in forum: General Questions
  2. Pierce
    Thread

    Answered First Layer Extrusion

    I am having a problem with extruding the first layer. When the printhead is off of the print bed (5 cm or so) it will extrude no problem, when i...
    Thread by: Pierce, Apr 16, 2018, 3 replies, in forum: General Questions
  3. Pierce
    Post

    Unanswered E3D V6 Installation

    #include "Marlin.h" #include "SdFatConfig.h" #include "SdVolume.h"...
    Post by: Pierce, Jan 16, 2018 in forum: Troubleshooting
  4. Pierce
    Post

    Unanswered E3D V6 Installation

    The guide said that the firmware needs to be modified for the new thermistors.
    Post by: Pierce, Jan 14, 2018 in forum: Troubleshooting
  5. Pierce
    Post

    Unanswered E3D V6 Installation

    Okay! I have everything installed but I cannot seem to find a link for the firmware that is still good and a few google searches turned up nothing.
    Post by: Pierce, Jan 14, 2018 in forum: Troubleshooting
  6. Pierce
    Post

    Unanswered E3D V6 Installation

    Yes I have already printed a new quick release and fan holder, could you link the fan shroud again as I’m having trouble locating it. Thanks!
    Post by: Pierce, Jan 12, 2018 in forum: Troubleshooting
  7. Pierce
    Thread

    Unanswered E3D V6 Installation

    Hello All, This is my first post as I am new to the forum. I have the R1 Plus and am looking to install the E3D V6 upgrade. I have the hot end all...
    Thread by: Pierce, Jan 11, 2018, 13 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again