1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. solerift
    Post

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    That did it. Thank you!
    Post by: solerift, May 14, 2018 in forum: Troubleshooting
  2. solerift
    Post

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    Update: Arduino kits + "Full Graphic" LCDs arrived. 1) Assembled one of them and uploaded Robo 3D R1 PLUS V2 Firmware. 2) Printed Solid 20...
    Post by: solerift, May 14, 2018 in forum: Troubleshooting
  3. solerift
    Post

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    Got it. Bad board in a refurb. That's good news, by Monday evening I should have a functional printer + LCD. Thanks to both of you!
    Post by: solerift, May 12, 2018 in forum: Troubleshooting
  4. solerift
    Post

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    I agree - there would be no reason to change it. Still, everything about this printer functions properly other than the Printed Solid LCD. I...
    Post by: solerift, May 12, 2018 in forum: Troubleshooting
  5. solerift
    Post

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    Also - if this is a firmware issue - a new board will not address the problem when I load the same V2 firmware from Robos website. I attached...
    Post by: solerift, May 11, 2018 in forum: Troubleshooting
  6. solerift
    Post

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    Its the Arduino or firmware. As stated, the same LCD, hooked up to my other Robo R1's, works just fine. Other LCDs which are working perfectly...
    Post by: solerift, May 11, 2018 in forum: Troubleshooting
  7. solerift
    Thread

    Solved Printed Solid Smart Controller XXL - not working, displays two lines of solid rectangles

    I've seen the other forum conversation in which identical symptoms were described, and the issue was solved with a new LCD. Unfortunately, that...
    Thread by: solerift, May 11, 2018, 13 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again