1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Frederik Seixas
    Post

    Answered Uneven prints, filament drag, etc...HELP!

    Thanks! I'll report back soon. On a final note, does Robo offer a repair service? I understand there would be significant costs. Sent from my...
    Post by: Frederik Seixas, Sep 24, 2018 in forum: Troubleshooting
  2. Frederik Seixas
    Post

    Answered Uneven prints, filament drag, etc...HELP!

    I may buy SImply3D as I was seeing some good things about it. When you have a moment, could you share a sample setup/config for a benchmark print...
    Post by: Frederik Seixas, Sep 24, 2018 in forum: Troubleshooting
  3. Frederik Seixas
    Post

    Answered Uneven prints, filament drag, etc...HELP!

    Sorry, we're using the MatterControl slicer as we have used it in the past to make good prints, and also have tried to use Repetier but with no...
    Post by: Frederik Seixas, Sep 24, 2018 in forum: Troubleshooting
  4. Frederik Seixas
    Post

    Answered Uneven prints, filament drag, etc...HELP!

    So as for a little more background, we haven't used our R1 plus in about 10 months and it printed fine before. It only began to show these issues...
    Post by: Frederik Seixas, Sep 24, 2018 in forum: Troubleshooting
  5. Frederik Seixas
    Post

    Answered Uneven prints, filament drag, etc...HELP!

    Thanks Mark. Sorry for the delay as I only had time this weekend to work on it again. So I've had some success now, but only marginally. The...
    Post by: Frederik Seixas, Sep 24, 2018 in forum: Troubleshooting
  6. Frederik Seixas
    Thread

    Answered Uneven prints, filament drag, etc...HELP!

    So I've been messing (I say that playfully) x and z axes but with nominal improvements. As you can see in the attached picture the prints always...
    Thread by: Frederik Seixas, Sep 10, 2018, 15 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again