1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. san_kart
    Thread

    Answered Z motors not moving when attached

    Hi guys, so this started happening yesterday with my Robo R1. The problem starts when I join the motor and the Z axis and TIGHT THE SCREW on the...
    Thread by: san_kart, Oct 8, 2016, 12 replies, in forum: Troubleshooting
  2. san_kart
    Post

    Solved Bed and hot end not getting hot.

    So I guess buying a new heat bed is the best and quickest option. Thank you very much.
    Post by: san_kart, Aug 9, 2016 in forum: Troubleshooting
  3. san_kart
    Post

    Solved Bed and hot end not getting hot.

    The bed was bad connected :$. I´ve verified and all connection and good now. Now something interesting happened. I was checking all conections to...
    Post by: san_kart, Aug 8, 2016 in forum: Troubleshooting
  4. san_kart
    Post

    Solved Bed and hot end not getting hot.

    I can preheat the extruder. I can´t preheat the bed, and it shows that its actual temp is 0°C. So you´re probably right.:p How can I fix it? Or...
    Post by: san_kart, Aug 8, 2016 in forum: Troubleshooting
  5. san_kart
    Post

    Solved Bed and hot end not getting hot.

    I installed Cura again on my laptop and when I wanted to print again, "temperature heated bed switched off" error pop out. It stopped when...
    Post by: san_kart, Aug 8, 2016 in forum: Troubleshooting
  6. san_kart
    Thread

    Solved Bed and hot end not getting hot.

    Hello guys, Few days ago the bed didn´t want to heat up. I usually pre heat everything on MatterControl and then change to Cura to start printing....
    Thread by: san_kart, Aug 8, 2016, 9 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again