1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. fred t modesta
    Post

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    can you recommend one? it really bothers me that I upgraded and starting having this problem. I even reinstalled cura 4 but I cant get the results...
    Post by: fred t modesta, May 13, 2021 in forum: Troubleshooting
  2. fred t modesta
    Post

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    well i figured out that it wont print unless 190. added a fifth top layer. but I am still getting holes and overall poor results compared to what...
    Post by: fred t modesta, May 13, 2021 in forum: Troubleshooting
  3. fred t modesta
    Post

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    I started a print at 180. no movement on the extruder gear. I raised the temp to 200 and it stared to print. i havent used this printer in a while...
    Post by: fred t modesta, May 13, 2021 in forum: Troubleshooting
  4. fred t modesta
    Post

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    I think I am making progress. thaks for your help. but for every step forward I seem to be taking a step back. I was trying to print a new cube...
    Post by: fred t modesta, May 13, 2021 in forum: Troubleshooting
  5. fred t modesta
    Post

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    You were right on the support. It was on by default. I enabled jerk and acceleration. doing a test now. what do you thing is causing this[ATTACH]
    Post by: fred t modesta, May 13, 2021 in forum: Troubleshooting
  6. fred t modesta
    Post

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    I started over with the newest octoprint verion. thats where the problems started.
    Post by: fred t modesta, May 13, 2021 in forum: Troubleshooting
  7. fred t modesta
    Thread

    Unresolved Cura 4.9.1 and octoprint 1.6 fail

    HI , i am an old member but had to create a new profile. locked out of password reset. So I decided to start over with octoprint since I had...
    Thread by: fred t modesta, May 13, 2021, 12 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again