1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. scott treichler
    Thread

    Partial Answer stepper motor for extruder will not run during print, works from control panel in software

    When I start a print the extruder motor does not run, it will extrude if I use the button on the control panel in the software, extruder is up to...
    Thread by: scott treichler, Feb 4, 2017, 2 replies, in forum: Troubleshooting
  2. scott treichler
    Post

    Unanswered very poor print

    Mark, thanks a bunch you nailed it. I pulled the bottom off and a small piece of filament had gotten stuck in the fan, pulled that out and its...
    Post by: scott treichler, Jun 6, 2016 in forum: Troubleshooting
  3. scott treichler
    Post

    Unanswered very poor print

    That for the quick response. Yes if I command 10mm to G code it moves 10. Are you referring to the fan that cools the board? I will check that,...
    Post by: scott treichler, Jun 6, 2016 in forum: Troubleshooting
  4. scott treichler
    Thread

    Unanswered very poor print

    Have a R1 that I have printed hundreds of hours on. After printing about3 days straight all of a sudden the prints are terrible. It’s like it is...
    Thread by: scott treichler, Jun 5, 2016, 5 replies, in forum: Troubleshooting
  5. scott treichler
    Post

    Unresolved R1 does not extrude during print

    seems strange that MC started acting up after all this time, have three printers and use it on all of them. I know a lot of people really don't...
    Post by: scott treichler, Mar 20, 2016 in forum: Troubleshooting
  6. scott treichler
    Post

    Unresolved R1 does not extrude during print

    Sorry I meant manual through the software. I switched to Cura slicer and it works fine, I tried reloading the software and that did not help with...
    Post by: scott treichler, Mar 20, 2016 in forum: Troubleshooting
  7. scott treichler
    Post

    Unresolved R1 does not extrude during print

    how can it run the stepper motor in manual mode in the motor is un plugged?
    Post by: scott treichler, Mar 20, 2016 in forum: Troubleshooting
  8. scott treichler
    Thread

    Unresolved R1 does not extrude during print

    after hundreds of hours my extruder has stopped extruding but only during a print, works fine manually through software, even does the retract...
    Thread by: scott treichler, Mar 19, 2016, 12 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again