1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. ruinedmonk
    Post

    Solved Extruder motor going in to overdrive when printing

    deleted the printer from matter control and re installed it. all fixed. Cura looks good. just dont have time to try ti and get it all perfect...
    Post by: ruinedmonk, Apr 5, 2016 in forum: Troubleshooting
  2. ruinedmonk
    Post

    Solved Extruder motor going in to overdrive when printing

    it is something to do with matter control. I used my other robo printer's laptop and the printer worked fine. Time to uninstall and reinstall and...
    Post by: ruinedmonk, Apr 4, 2016 in forum: Troubleshooting
  3. ruinedmonk
    Thread

    Solved Extruder motor going in to overdrive when printing

    Hi all im having problems with my extruder motor. If I tell the printer to extrude though matter control it works fine. But when I i start a print...
    Thread by: ruinedmonk, Apr 4, 2016, 5 replies, in forum: Troubleshooting
  4. ruinedmonk
    Post

    Unresolved Print Quality

    how do i do this?
    Post by: ruinedmonk, Mar 18, 2016 in forum: Troubleshooting
  5. ruinedmonk
    Post

    Unresolved Print Quality

    I have just calibrated the right one. How do I save it permanently? that has a help a bit but is still isn't as good as the other printer.
    Post by: ruinedmonk, Mar 18, 2016 in forum: Troubleshooting
  6. ruinedmonk
    Thread

    Unresolved Print Quality

    I have 2 robo 3d both with pretty much the same setting on apart from Z off set. But the print quality between the 2 is stupidly different, The...
    Thread by: ruinedmonk, Mar 18, 2016, 4 replies, in forum: Troubleshooting
  7. ruinedmonk
    Post

    Unanswered model height to tall

    the first layer sticks perfectly. Im printing component parts that fit in to grooves in 2 pieces of wood.
    Post by: ruinedmonk, Mar 16, 2016 in forum: Troubleshooting
  8. ruinedmonk
    Thread

    Unanswered model height to tall

    Hi my model height is a little off. All my models are coming out 0.3mm- 0.5mm to tall. I have 8mm threaded rod and the correct firmware. What can...
    Thread by: ruinedmonk, Mar 1, 2016, 4 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again