1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Print Quality

Discussion in 'Troubleshooting' started by ruinedmonk, Mar 18, 2016.

  1. ruinedmonk

    ruinedmonk New Member

    Joined:
    May 26, 2015
    Messages:
    10
    Likes Received:
    1
    I have 2 robo 3d both with pretty much the same setting on apart from Z off set. But the print quality between the 2 is stupidly different, The Left one is what im after. How do i go about getting rid of all the texture on the right one? 3d prints.jpg
     
    #1 ruinedmonk, Mar 18, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Calibrate the extruder for start.

     
    #2 mark tomlinson, Mar 18, 2016
  3. ruinedmonk

    ruinedmonk New Member

    Joined:
    May 26, 2015
    Messages:
    10
    Likes Received:
    1
    I have just calibrated the right one. How do I save it permanently? that has a help a bit but is still isn't as good as the other printer.
     
    #3 ruinedmonk, Mar 18, 2016
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    You need to mod the firmware, then reupload it to the Arduino inside the Robo.
     
    #4 WheresWaldo, Mar 18, 2016
  5. ruinedmonk

    ruinedmonk New Member

    Joined:
    May 26, 2015
    Messages:
    10
    Likes Received:
    1
    how do i do this?
     
    #5 ruinedmonk, Mar 18, 2016

Share This Page