1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Luke
    Post

    Unanswered Stepper Driver issues

    I don't think I did. Unless the bottom set sit in a different orientation than the top. Like I said it was the Y driver that burnt up, and I...
    Post by: Luke, Nov 11, 2016 in forum: Troubleshooting
  2. Luke
    Post

    Unanswered Stepper Driver issues

    Thats what I think. Can I replace the stepper drivers with some generic ones or do I need to go through ROBO to get theirs? The arduino itself...
    Post by: Luke, Nov 11, 2016 in forum: Troubleshooting
  3. Luke
    Thread

    Unanswered Stepper Driver issues

    So while trying to start a PVA mold print today I had a strange turn of events happen. First I hit "print" only to find that my extruder motor was...
    Thread by: Luke, Nov 11, 2016, 8 replies, in forum: Troubleshooting
  4. Luke
    Thread

    Unanswered Printer stoping after randomly mid print

    So my robo began stoping mid print. This sounds like an issue with the ramps but the cooling fan for it is always running, and never unplugged,...
    Thread by: Luke, Sep 7, 2016, 3 replies, in forum: Troubleshooting
  5. Luke
    Post

    ROBO R1+ aluminum bed?

    Long story short, I have had 2 robo printers. The first was sent back due to issues with the controller. On both printers, the tin tape has slowly...
    Post by: Luke, Aug 22, 2016 in forum: Mods and Upgrades
  6. Luke
    Post

    ROBO R1+ aluminum bed?

    Not exactly sure yet, like I said I need a look under there to see how everything can fit. Some kind of clamping bracket. "clamping bracket" it...
    Post by: Luke, Aug 22, 2016 in forum: Mods and Upgrades
  7. Luke
    Thread

    ROBO R1+ aluminum bed?

    So I have been thinking about pulling the glass bed off of my robo, to have a good look at exactly how it works, so I can craft an aluminum bed in...
    Thread by: Luke, Aug 22, 2016, 9 replies, in forum: Mods and Upgrades
Showing results 1 to 7 of 7
Search Again