1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Guy Compton
    Post

    R2 Connection Interrupted...Reset from LCD, good until next boot up?

    I never figured mine out, logs were sent to Robo3D but they didn't see anything. I just reset it and move on. Will take more time after the...
    Post by: Guy Compton, Dec 25, 2017 in forum: Troubleshooting
  2. Guy Compton
    Post

    There was an issue retrieving the source of the webcam.

    My Octoprint would never display webcam and gave the same error as others. Cura displayed the video fine...once your started the Video Stream. I...
    Post by: Guy Compton, Nov 21, 2017 in forum: Troubleshooting
  3. Guy Compton
    Post

    R2 Connection Interrupted...Reset from LCD, good until next boot up?

    It happens when I first power on the Robo3D. The screen says Connection Interrupted and has the Reset button and nothing else. If I touch the...
    Post by: Guy Compton, Oct 28, 2017 in forum: Troubleshooting
  4. Guy Compton
    Post

    R2 Connection Interrupted...Reset from LCD, good until next boot up?

    Yes, it is running the latest update.
    Post by: Guy Compton, Oct 26, 2017 in forum: Troubleshooting
  5. Guy Compton
    Post

    R2 Connection Interrupted...Reset from LCD, good until next boot up?

    Yes, using Wifi and has full signal. Device is about 20 ft from the router. Out of the box it did not have this issue.
    Post by: Guy Compton, Oct 26, 2017 in forum: Troubleshooting
  6. Guy Compton
    Thread

    R2 Connection Interrupted...Reset from LCD, good until next boot up?

    Searched forums and attempted all of the recommended fixes. Check cables, Pi, Robo Board etc... When I first turn it on the unit says Connection...
    Thread by: Guy Compton, Oct 26, 2017, 14 replies, in forum: Troubleshooting
  7. Guy Compton
    Post

    Success?? with NinjaFlex or other flexible

    I will, thanks
    Post by: Guy Compton, Oct 16, 2017 in forum: General Questions
  8. Guy Compton
    Post

    Success?? with NinjaFlex or other flexible

    Thanks for the response, maybe I shouldn't say retired but UPGRADED. Solidoodle was ALWAYS a temperamental PITA. R1 was amazing once the minor...
    Post by: Guy Compton, Oct 16, 2017 in forum: General Questions
  9. Guy Compton
    Thread

    Success?? with NinjaFlex or other flexible

    Retiring my Solidoodle and Robo3D R1 Plus for the R2. It was a huge pain to get these both to print correctly with NinjaFlex. Has anyone attempted...
    Thread by: Guy Compton, Oct 16, 2017, 23 replies, in forum: General Questions
Showing results 1 to 9 of 9
Search Again