1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Best way to clean robo3d PLA non-heated bed?

Discussion in 'Troubleshooting' started by TheOneRaven, Mar 9, 2014.

Thread Status:
Not open for further replies.
  1. TheOneRaven

    TheOneRaven New Member

    Joined:
    Mar 6, 2014
    Messages:
    22
    Likes Received:
    0
    Any help would be nice... due to calibration problems, the plastic is so thin on this, that it sticks and won't come off...

    Any thoughts on scrapers or solvents?

    Thanks - TOR
     
    #1 TheOneRaven, Mar 9, 2014
Thread Status:
Not open for further replies.

Share This Page