I've lurked these forums for along time, and if anyone has some time, I would appreciate some help. After having MANY, MANY issues with my Kickstarter C2, the Robo support team stepped up and agreed to replace my original C2 (filament sensor never there, extruder/z-axis would not stay set and put divots in my bed, replaced touchscreen, etc etc). I received my replacement C2 unit a few weeks back, and I finally had a chance to set it up today. And of course, I checked for new C2's firmware right after I place it on WiFi. I upgraded my original unit's firmware probably close to a dozen times, so I didn't think anything of it. The device completed it's upgrade routine, restarted, and then proceeded to hang on the Robo splash screen for the next 20+ minutes. I'm afraid my image on the Raspberry Pi might have been corrupted Would anyone be able to help me obtain a recent factory image, or have another suggestion I could try? Thanks to everyone in this forum, I've learned lots about this machine and 3D printing from the numerous threads here. I just can't wait to be operational again (it's been many months since I have been able to 3D print).