1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Can't get good circle after installing bed levelers...

Discussion in 'Troubleshooting' started by MikeZ_TWC, Mar 7, 2014.

Thread Status:
Not open for further replies.
  1. MikeZ_TWC

    MikeZ_TWC New Member

    Joined:
    Dec 11, 2013
    Messages:
    9
    Likes Received:
    2
    hi all -

    my y axis drive belt came off when installing the spring leveler upgrade.

    the unit will now only print oval-ish warped circles when calling for it to print circles (but the bed is perfectly level now :) )

    i am assuming this threw something in the y off. how do I adjust / calibrate the y back to normal? i got a fully assembled unit so I am not familiar with the factory calibration.

    thanks,
    Mike
     
  2. Drew Eby

    Drew Eby Member

    Joined:
    Feb 26, 2014
    Messages:
    50
    Likes Received:
    5
    Did the belt itself come out of the clip? If so it may be loose. To put it back in pull it tight to where its like low guitar string. Then put it back in the clip and re screw it onto the bed.
     
Thread Status:
Not open for further replies.

Share This Page