1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Clogged Extruder

Discussion in 'Troubleshooting' started by Clark Sechrest, Nov 24, 2013.

Thread Status:
Not open for further replies.
  1. Clark Sechrest

    Clark Sechrest New Member

    Joined:
    Mar 1, 2013
    Messages:
    26
    Likes Received:
    3
    For some reason my extruder seems to be clogged, when i heat it up nothing will come out and when have it heated and open the extruder i can not push the filament through the nozzle like i could before. Im not sure what would cause this issue. Anyone experience a similar problem? or have any ideas on how to get the blockage cleared?
     
    #1 Clark Sechrest, Nov 24, 2013
  2. Melody Bliss

    Melody Bliss New Member

    Joined:
    Nov 17, 2013
    Messages:
    276
    Likes Received:
    81
    Not sure what caused your clog but Robo3D put up a video on how to clear it (and replace the internal ptfe tube)

     
    #2 Melody Bliss, Nov 24, 2013
    2 people like this.
Thread Status:
Not open for further replies.

Share This Page