1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Extrude First Layer

Discussion in 'Troubleshooting' started by Jonathan Kagan, Jun 8, 2014.

Thread Status:
Not open for further replies.
  1. Jonathan Kagan

    Jonathan Kagan New Member

    Joined:
    Jun 7, 2014
    Messages:
    14
    Likes Received:
    0
    I am using a 195 extrude first layer temp and a 185 extruder temp (in the Filament settings) , but the extruder is only heating up to 185 before printing the first layer. Is there a setting I am missing somewhere?

    Many thanks.
     
    #1 Jonathan Kagan, Jun 8, 2014
  2. Galaxius

    Galaxius Well-Known Member

    Joined:
    Jan 18, 2014
    Messages:
    632
    Likes Received:
    342
    What software and slicer are you using?
     
    #2 Galaxius, Jun 8, 2014
  3. Jonathan Kagan

    Jonathan Kagan New Member

    Joined:
    Jun 7, 2014
    Messages:
    14
    Likes Received:
    0
    I am using MatterControl 1.1, with the Slic3r engine.
     
    #3 Jonathan Kagan, Jun 8, 2014
Thread Status:
Not open for further replies.

Share This Page