Fixing bed temp issues and crashing!

Hey Guys!

After installing the Smart LCD Upgrade on my printer I noticed that after about 30 - 40 minutes my bed temp would start dropping like crazy and my print ultimately would stop and the Arduino board would crash and I would have to reset the printer. After having this happen about ~5 times I did some research and figured out the RAMP board was overheating. I created a video showing what I did to fix it and it's a very easy fix and the printer worked for hours without issue holding 70c on the bed without any issues afterwards. Hope this video helps solve your problems!



Thanks,
Jerry (aka. Barnacules)
http://barnnerd.com