1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

G-code command for live z-axis offset

Discussion in 'Troubleshooting' started by Mike Dioguardo, Oct 11, 2014.

Thread Status:
Not open for further replies.
  1. Mike Dioguardo

    Mike Dioguardo New Member

    Joined:
    Aug 27, 2014
    Messages:
    21
    Likes Received:
    4
    I noticed you can send commands to the printer as it is printing in the terminal in MC. Alot of times since i use ABS glue method to prevent parts from warping my extruder will be a tad bit too high or a tad bit too low during the print depending on the thickness of the layer of glue.

    Could anyone tell me the code use to offset the z-axis as its printing? I know there is one, just not sure how to write it.
     
    #1 Mike Dioguardo, Oct 11, 2014
    Last edited by a moderator: Oct 11, 2014
  2. Ziggy

    Ziggy Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    707
    Likes Received:
    530
    #2 Ziggy, Oct 11, 2014
  3. Mike Dioguardo

    Mike Dioguardo New Member

    Joined:
    Aug 27, 2014
    Messages:
    21
    Likes Received:
    4
    I do have the auto level version of the robo (purchased mine the 2nd to last week of this past August).
    I would rather use the M565 command rather then modify the firmware for baby stepping.
     
    #3 Mike Dioguardo, Oct 11, 2014
Thread Status:
Not open for further replies.

Share This Page