Great Print after Autolevel

I followed Mike's instructions, augmented by these:

http://forums.robo3dprinter.com/index.php?threads/test-prints-are-pretty-rough…why.2642/#post-20590

I also am using an experimental head fashioned after the IndieGogo Prometheus project:

https://www.indiegogo.com/projects/prometheus-hot-end

I had one hot end that was a reject (the tip broke off!), I switched to another and it was all rock and roll.

This 25 mm calibration cube printed with .05 to .30 tolerances. Good enough for me! Still a bit of Y-axis roughness but it will sort soon enough. (Belts, Gear).