1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Hot end can't go above ~160'c anymore :(

Discussion in 'Troubleshooting' started by poxcx, Apr 28, 2014.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. poxcx

    poxcx Member

    Joined:
    Feb 20, 2013
    Messages:
    37
    Likes Received:
    5
    Problem Resolved.

    Robo sent me a replacement heat core, I didnt think that would work but when i removed the heat shrink stuff from the leads i found two very poor dry solder joints and 1 side was loose, removed the resistor and it was dark and miscolored. Replaced it, soldered it properly and back to printing again, yay.
     
    #21 poxcx, Jun 12, 2014
    3 people like this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page