1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Ideal filament output

Discussion in 'Troubleshooting' started by Casey, Nov 28, 2013.

Thread Status:
Not open for further replies.
  1. Casey

    Casey New Member

    Joined:
    Nov 22, 2013
    Messages:
    17
    Likes Received:
    2
    I keep on seeing threads where peoples extruders are too high, and I was wondering if someone who is getting really good prints could take an exact measurement of a single pass skirt or something and report on both the thickness and width of the line. This would help people (myself very much included) get the right extruder height and feed rate.
     
    #1 Casey, Nov 28, 2013
  2. Casey

    Casey New Member

    Joined:
    Nov 22, 2013
    Messages:
    17
    Likes Received:
    2
    My current settings give me a thickness of 0.26mm and 0.55mm wide.
     
    #2 Casey, Nov 28, 2013
Thread Status:
Not open for further replies.

Share This Page