1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Machine stuck in Z axis during set up

Discussion in 'Technical Support' started by Rajesh Balasubramanian, Nov 14, 2013.

  1. Rajesh Balasubramanian

    Rajesh Balasubramanian New Member

    Joined:
    Nov 10, 2013
    Messages:
    1
    Likes Received:
    0
    I was setting the table for z axiz - zero setting and the nazzle is not moving up od down when I manually rotate the nuts.Please help
     
    #1 Rajesh Balasubramanian, Nov 14, 2013

Share This Page