1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Mark2 Mfr Suggestion - Tapered z nut holes

Discussion in 'Requests and Suggestions' started by Thor, Mar 2, 2014.

  1. Thor

    Thor Member

    Joined:
    Nov 19, 2013
    Messages:
    64
    Likes Received:
    19
    If you're going to do auto-leveling,you're going to run into backlash problems with your current setup (I have about 2 degrees of freedom in the posts around the nuts). You can solve this (and make it friendly for English/metric as well) by putting a taper on those holes...
     
    #1 Thor, Mar 2, 2014
    2 people like this.

Share This Page