1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Matter control is the most optimistic software ever :)

Discussion in 'Troubleshooting' started by Mikethinks, Jul 14, 2014.

Thread Status:
Not open for further replies.
  1. Mikethinks

    Mikethinks Active Member

    Joined:
    Mar 8, 2014
    Messages:
    141
    Likes Received:
    79
    To determine actual print times...just multiply what MC estimates by about 1.7 Not sure if theres any way to get a more accurate measurement, but wow its always WAY off.
     
    #1 Mikethinks, Jul 14, 2014
  2. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    Most software have that as a configuration setting when you load a printer Repetier is also way off witht he default setting and the larger the print the more it is off I usually multiply by 1.5 to get something accurate if I really am time constrained other wise I just let it finish when it finishes
     
    #2 tesseract, Jul 14, 2014
Thread Status:
Not open for further replies.

Share This Page