1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Nozzle hits print after finished.

Discussion in 'Troubleshooting' started by Soupaboy, Nov 23, 2013.

Thread Status:
Not open for further replies.
  1. Soupaboy

    Soupaboy Active Member

    Joined:
    Sep 29, 2013
    Messages:
    287
    Likes Received:
    49
    hi, after my print finished the nozzle just stabbed right into it and tried to move through it. how can i set it not to do this or to raise the nozzle after each prints. G-code?
     
    #1 Soupaboy, Nov 23, 2013
  2. 1d1

    1d1 Active Member

    Joined:
    Feb 21, 2013
    Messages:
    418
    Likes Received:
    216
    The z-limit switch at the bottom of the right precision rod has an adjustable screw for that. Read threads on "throwing your nuts" and bed calibration. It's all in here... somewhere...
    Good luck!
     
    #2 1d1, Nov 23, 2013
Thread Status:
Not open for further replies.

Share This Page