1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Printing in ABS for the first time, wish me luck...

Discussion in 'Troubleshooting' started by Melody Bliss, Nov 27, 2013.

Thread Status:
Not open for further replies.
  1. Melody Bliss

    Melody Bliss New Member

    Joined:
    Nov 17, 2013
    Messages:
    276
    Likes Received:
    81
    (crossed fingers)

    I'm printing with the extruder at 230 and the bed at 100. The bed has hairspray on it.
     
    #1 Melody Bliss, Nov 27, 2013
  2. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    try and keep the fan off it will reduce any temperature variations
    whats the print?
    Print with large flat bases will have the highest likiehood of warping so really focus whatever you can do to keep the temp from changing
     
    #2 tesseract, Nov 27, 2013
  3. Melody Bliss

    Melody Bliss New Member

    Joined:
    Nov 17, 2013
    Messages:
    276
    Likes Received:
    81
    I'm just doing test prints first and fine tuning before I print anything big :)

    The calibration pyramid just finished.

    [​IMG]


    Sent from my iPhone using Tapatalk
     
    #3 Melody Bliss, Nov 27, 2013
  4. Melody Bliss

    Melody Bliss New Member

    Joined:
    Nov 17, 2013
    Messages:
    276
    Likes Received:
    81
    sigh. Looks like like I need to do the relay mod. I'm not able to sustain 100 for the bed temp.
     
    #4 Melody Bliss, Nov 27, 2013
Thread Status:
Not open for further replies.

Share This Page