1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Rating on the ROBO 3D?

Discussion in 'Off Topic' started by 3D Printer Man, May 30, 2016.

?

What would you rate the printer on a scale to 1-10?

  1. 1

    0 vote(s)
    0.0%
  2. 2

    100.0%
  3. 3

    0 vote(s)
    0.0%
  4. 4

    0 vote(s)
    0.0%
  5. 5

    0 vote(s)
    0.0%
  6. 6

    0 vote(s)
    0.0%
  7. 7

    0 vote(s)
    0.0%
  8. 8

    0 vote(s)
    0.0%
  9. 9

    0 vote(s)
    0.0%
  10. 10

    0 vote(s)
    0.0%
Multiple votes are allowed.
  1. 3D Printer Man

    3D Printer Man Active Member

    Joined:
    May 21, 2016
    Messages:
    226
    Likes Received:
    57
    What would you guys rate the robo? In my experience it is good/great!
    First, got the printer great for the first 2 1/2 months. Then, I was busy, so I stopped printing for a month. So I have now returned for about a 1/2 month. And then we I ran out of glue, I used the glue that is not recommended, so make sure it is elemers. My fault, but then the prints would get so stuck to the bed that it would be next to impossible to get of them. So then saw a bed that cracked took two days to replace it. Then I accidentally supper glue the bed to the frame. After that, I had a clogged hotted, finally removed the filament. Next, I got a nozzle tip, replaced the old one. Some how the thermistor broke. And now I am stuck. So be carefully around 3 months. I would recommend the printer. On a scale of 1-10, I would rate it at this time 8.5-9/10.
     

Share This Page