Unresolved Slic3r engine in Matterslice

Hi guies,

I tried to use the Slic3r engine in the new update of MatterControl and the slicing and model generated (well the sliced display) looks great but when I tried to print the sliced model... The Robo stayed like quite, polite and well didn't print at all Is there something to do to start the printing? I have the last Mattercontrol update the Robo3D R1 with auto level etc...

Thanks.
Xavier

 

I have exactly the same problem. I'm certain the bug is in the software and not the firmware as I have rolled back the firmware three time with no improvement.


Sent from my iPad using Tapatalk