1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Stepper or board failure

Discussion in 'Technical Support' started by 1d1, Dec 13, 2013.

  1. 1d1

    1d1 Active Member

    Joined:
    Feb 21, 2013
    Messages:
    418
    Likes Received:
    216
    Hi Guys,

    My extruder stepper stopped stepping yesterday. I don't yet know if it is the stepper or the board or even the wiring though I have checked that the connections all seem secure. I will do more trouble shooting this morning. This is just a "heads up" to, hopefully, diminish down time. Tip, suggestions or a wiring diagram would be helpful...
    Thanks,
    Dean
     
    #1 1d1, Dec 13, 2013
  2. 1d1

    1d1 Active Member

    Joined:
    Feb 21, 2013
    Messages:
    418
    Likes Received:
    216
    OK. The stepper works when connectors are switched. So, the board is not doing the job. I will check further for connections as a problem on the board itself.
     
    #2 1d1, Dec 13, 2013
  3. 1d1

    1d1 Active Member

    Joined:
    Feb 21, 2013
    Messages:
    418
    Likes Received:
    216
    Can't see any obvious problems and I am at my trouble shooting threshold. Seems to be the board. What should we do?
    Thanks,
    Dean
     
    #3 1d1, Dec 13, 2013

Share This Page