1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Tips to improve the first layer of my prints

Discussion in 'Troubleshooting' started by Luis Alberto, Aug 23, 2016.

  1. Luis Alberto

    Luis Alberto Member

    Joined:
    Aug 10, 2016
    Messages:
    41
    Likes Received:
    8
    Greetings. Could you give any advice to improve the first layer of my prints? Here is the situation, when the print job has finished and remove the piece of the bed, some places on the first layer result with white spots. Is it because the adhesive type (I use hairsparay)? Or I have to configure some settings?
    Thank you for your help.
     
    #1 Luis Alberto, Aug 23, 2016
  2. Toro1966

    Toro1966 Active Member

    Joined:
    Jun 23, 2016
    Messages:
    398
    Likes Received:
    78
    If you post a picture it would be helpful for us to try and help you troubleshoot.

    Sent from my SAMSUNG-SM-G935A using Tapatalk
     
    #2 Toro1966, Aug 23, 2016
  3. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    It might be the hairspray or maybe the filament you are using or a combination. Can't think of any settings that would affect this. I use hairspray and did get some white spots when I used the robo blue sample that came with the printer. I have been printing in white lately so I can't remember if I am still getting that or not. :)
     
    #3 danzca6, Aug 23, 2016

Share This Page