1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Updating to V4 not working z axis properly

Discussion in 'Troubleshooting' started by Francisco Roura, Dec 10, 2014.

Thread Status:
Not open for further replies.
  1. Francisco Roura

    Francisco Roura New Member

    Joined:
    Dec 10, 2014
    Messages:
    2
    Likes Received:
    0
    Hi, I just bought a robo 3D 1 week ago, and i just used it 2 days, at second day just updated to firmware to V4, Now i cant get a single good print, because Z axis is not working while printing. It prints well first layer, but layer, 2, 3 4, etc just colide with the 3d priting. I dont understand why its happen, its the newest model, why its not working with the lastest upgrade.

    10805389_10205151118079165_1492745194_n.jpg 10836541_10205151117999163_1129303941_n.jpg
     
    #1 Francisco Roura, Dec 10, 2014
  2. Francisco Roura

    Francisco Roura New Member

    Joined:
    Dec 10, 2014
    Messages:
    2
    Likes Received:
    0
    Just Fixed it by: "You probably need to make sure your Z steps per mm are set to 2560" Mike Kelly Facebook group.
     
    #2 Francisco Roura, Dec 10, 2014
Thread Status:
Not open for further replies.

Share This Page