1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Volt

Discussion in 'Troubleshooting' started by Staffan, Nov 10, 2013.

Thread Status:
Not open for further replies.
  1. Staffan

    Staffan New Member

    Joined:
    Nov 10, 2013
    Messages:
    2
    Likes Received:
    0
    bild (1).JPG I am an international user, and I am trying to change the volt to European standard, but I don't have that red thing that is shown in the video. It seems I can't change volt. What should I do?
    Should I buy a converter for a 220 volt cord or can anything go wrong?
     
    #1 Staffan, Nov 10, 2013
  2. David Mortlock

    David Mortlock Active Member

    Joined:
    Feb 20, 2013
    Messages:
    240
    Likes Received:
    72
    First thing I would do is to report it to Robo3D people through their contact point at http://www.robo3dprinter.com/pages/technical-support and see what they say.

    I wouldn't power it up on 240v in case you end up putting 24v to the board. Who knows what might happen.
     
    #2 David Mortlock, Nov 10, 2013
  3. Staffan

    Staffan New Member

    Joined:
    Nov 10, 2013
    Messages:
    2
    Likes Received:
    0
    Thanks
     
    #3 Staffan, Nov 10, 2013
  4. Thamer Albahiti

    Thamer Albahiti Active Member

    Joined:
    Feb 20, 2013
    Messages:
    195
    Likes Received:
    36
    i wonder how that passed QC ?
     
    #4 Thamer Albahiti, Nov 10, 2013
    2 people like this.
Thread Status:
Not open for further replies.

Share This Page