Solved What is the settings for Repetier-host?

Hi,

What is the settings for the repetier-host software for the robo3d?

I remember when i got the printer i needed to set al the settings by my self (feedrate etc) but now i cant find the documentation?

BR

 

I found out after installing it that it was pre-setted for robo3d =)

 

So are you saying that once you down load repetier host, all the setting at correct for the Robo R1 printer with the enclosed bottom and you don't have to change anything. What slicer are you using, could you post a copy of you setup parameters.