1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Z Axis stop behavior

Discussion in 'Troubleshooting' started by MikeZ_TWC, Feb 28, 2014.

Thread Status:
Not open for further replies.
  1. MikeZ_TWC

    MikeZ_TWC New Member

    Joined:
    Dec 11, 2013
    Messages:
    9
    Likes Received:
    2
    hey guys,

    I discovered that my Z-axis stop switch was in backwards so I flipped it around. It appears now to not be working. I can push the z axis stop and the machine keeps moving.

    Is that expected behavior? How can I check / repair my z axis stop?

    Thanks,
    Mike
     
    #1 MikeZ_TWC, Feb 28, 2014
  2. warlocke

    warlocke Active Member

    Joined:
    May 10, 2013
    Messages:
    127
    Likes Received:
    58
    Check the wire connections. When you flipped it one might have broken loose or had a cold solder joint that is no longer making good connection.
     
    #2 warlocke, Feb 28, 2014
Thread Status:
Not open for further replies.

Share This Page