1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z axis wont travel up or down

Discussion in 'Troubleshooting' started by Kevin Nguyen, Dec 30, 2014.

Thread Status:
Not open for further replies.
  1. Kevin Nguyen

    Kevin Nguyen New Member

    Joined:
    Sep 2, 2014
    Messages:
    5
    Likes Received:
    8
    Just re installed my hexagon hot end when i found out my z axis wont travel up or down with G1 Z10 but can home. Im using simplify3d and i get this from the verbose



    SENT: G91

    SENT: G1 Z10 F1200

    SENT: G90

    RECEIVED: ok

    RECEIVED: Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
     
    #1 Kevin Nguyen, Dec 30, 2014
  2. Kevin Nguyen

    Kevin Nguyen New Member

    Joined:
    Sep 2, 2014
    Messages:
    5
    Likes Received:
    8
    thermisistor wasnt reading properly. checked connections and it fixed the problem
     
    #2 Kevin Nguyen, Dec 30, 2014
    3 people like this.
Thread Status:
Not open for further replies.

Share This Page