Separate names with a comma.
Thank you! i will print and try, and also give you a feedback!
See the attached pictures.
whrere is the bolts?
Hi, my Robo 3D is the first model from kickstarter and i have a quick question, on side of my bed is higher than the other, do exist a screw to...
OK, thnak you very much, i will try to replace the thermistors. ;)
i attached some pictures about my printer to confirm the thermistor.
[ATTACH] [ATTACH] [ATTACH]
So the thermistor is a class J ?
Hi, i'm back, i checked all and than my thermistor is gone, do you have the technical information of the 100 Kohm thermistor ?
thanks! i will spend some days dealing with this, then i give you a feedback! thanks again for your time!
There is another way to check/test the thermistor before buy a new one?
What is the advantages to change for this new hotend? i am new at 3d...
I have the original old one, do you thing thar is better change the hotend?
where can i buy theses items to fix and/or upgrade?
How can i try to fix or substitute this sensor? If i can't fix where can i buy a new one to replace?
Thanks for the fast answer
This is my first post, my printer is a R1 from the KickStarter, and the MatterControl suddenly sets the temperature 260 ºC as the...