1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by dmadsen

  1. dmadsen
    Post

    Hot end: another nice link for a good replacement part

    Which one should I order? 3mm or 1.75mm? (I have a Robo 3d R1) Robo 3D store is sold out of hot ends.
    Post by: dmadsen, Feb 11, 2017 in forum: Mods and Upgrades
  2. dmadsen
    Thread

    Does anyone know if Mattercontrol runs on an HP Chromebook?

    If not... is there a Robo3D R1 compatible print software for printing simple STL files that runs on a chromebook?
    Thread by: dmadsen, Oct 5, 2016, 3 replies, in forum: Software
  3. dmadsen
    Thread

    Solved PLA Warping Tips Needed

    Novice in need of direction. Robo3D R1 Matter control 1.5 Printing a flat/thin 6" square box lid. Every attempt has the corners warping up...
    Thread by: dmadsen, Sep 19, 2016, 1 replies, in forum: Troubleshooting
  4. dmadsen
    Post

    Solved Holes printing filled-in somehow.

    Makes sense. I was wondering if it would sag or not. Now I wish I hadn't canceled the print. I'll try popping our gauging it out after my next...
    Post by: dmadsen, Apr 20, 2016 in forum: Troubleshooting
  5. dmadsen
    Thread

    Solved Holes printing filled-in somehow.

    I have a GCODE that’s printing poorly from a TinkerCad-generated STL. It’s basically 1/2 of a poker chip rack that needs to be up on stilts. I...
    Thread by: dmadsen, Apr 20, 2016, 3 replies, in forum: Troubleshooting