1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by dwal53

  1. dwal53
    Post

    Print Bed is not heating

    Yes, I replaced the connectors. I typed the PN into amazon and ordered a pack of them. I Replaced the Extruder power connectopr as well because it...
    Post by: dwal53, Feb 16, 2018 in forum: General Questions
  2. dwal53
    Post

    Print Bed is not heating

    I found some burn damage on the green connectors on the electronics board. I ordered a new boards from Robo and a new hot end. I've installed...
    Post by: dwal53, Feb 16, 2018 in forum: General Questions
  3. dwal53
    Post

    Print Bed is not heating

    Yes, its around 21C-23C.
    Post by: dwal53, Feb 6, 2018 in forum: General Questions
  4. dwal53
    Thread

    Print Bed is not heating

    I have been experiencing issues with my print bed not heating up. Before I would just wiggle the wires and it work again. This time that is not...
    Thread by: dwal53, Feb 6, 2018, 9 replies, in forum: General Questions
  5. dwal53
    Post

    Solved X-Axis is not homing properly (R1+)

    OK, So i got the X to Home. Now when I Click Home all the Z Axis goes up...
    Post by: dwal53, Sep 10, 2017 in forum: Troubleshooting
  6. dwal53
    Thread

    Solved X-Axis is not homing properly (R1+)

    When I click the Home all button in Matter Control the Y and Z Axis' will home but the x will not move at all. When you hit print it will make a...
    Thread by: dwal53, Sep 10, 2017, 2 replies, in forum: Troubleshooting