1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Ely Cannon

  1. Ely Cannon
    Post

    Robo R2 - Print head runs into the bed during bed height checks pre print

    Thank you for getting me back up and running Mark and Tkoco
    Post by: Ely Cannon, Oct 1, 2020 in forum: Troubleshooting
  2. Ely Cannon
    Post

    Robo R2 - Print head runs into the bed during bed height checks pre print

    If I did replace the sensor is this the part? Sold out now at partsbuilt but I will put myself on the wait list if this is correct- I will try...
    Post by: Ely Cannon, Oct 1, 2020 in forum: Troubleshooting
  3. Ely Cannon
    Post

    Robo R2 - Print head runs into the bed during bed height checks pre print

    It has a new buildtak surface on it, but I do need a new bed once they are available from the parts supplier as the original surface is not in the...
    Post by: Ely Cannon, Oct 1, 2020 in forum: Troubleshooting
  4. Ely Cannon
    Post

    Robo R2 - Print head runs into the bed during bed height checks pre print

    I have commented out the G36 command and it seems to have done the same thing you described and it s printing. Is it necessary to replace the IR...
    Post by: Ely Cannon, Sep 30, 2020 in forum: Troubleshooting
  5. Ely Cannon
    Post

    Robo R2 - Print head runs into the bed during bed height checks pre print

    G29 Doesn't appear in my gcode. My assumption is that it would be in the settings in octoprint console in the - gcode scripts - "before print...
    Post by: Ely Cannon, Sep 30, 2020 in forum: Troubleshooting
  6. Ely Cannon
    Thread

    Robo R2 - Print head runs into the bed during bed height checks pre print

    All of a sudden my Robo r2 is not able to make it past the 3rd bed height check point it does before starting a print up. It makes it through the...
    Thread by: Ely Cannon, Sep 30, 2020, 9 replies, in forum: Troubleshooting