1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Folk Hero

  1. Folk Hero
    Post

    Answered G-Code Question

    Thanks. That is a nice setup.
    Post by: Folk Hero, Jun 28, 2017 in forum: General Questions
  2. Folk Hero
    Post

    Answered G-Code Question

    What about putting a line in before shutoff like "G1 E-100 F1500 ;retract filament 100 mm @ 1500mm/min" to extract the filament before it turns off?
    Post by: Folk Hero, Jun 28, 2017 in forum: General Questions
  3. Folk Hero
    Post

    Answered G-Code Question

    I like your idea. I could sleep at night without worrying about the printer running.
    Post by: Folk Hero, Jun 27, 2017 in forum: General Questions
  4. Folk Hero
    Post

    Answered G-Code Question

    Bummer.
    Post by: Folk Hero, Jun 27, 2017 in forum: General Questions
  5. Folk Hero
    Thread

    Answered G-Code Question

    Is there a G-Code that will turn a ROBO 1+ off after a print is finished? Tim
    Thread by: Folk Hero, Jun 27, 2017, 18 replies, in forum: General Questions
  6. Folk Hero
    Thread

    Solved Is this correct?

    Should the number be this low or should I type in the 430 and hit go? [ATTACH]
    Thread by: Folk Hero, Jun 23, 2017, 0 replies, in forum: General Questions
  7. Folk Hero
    Post

    Solved Can't find printer

    So would you just disable it or uninstall it? Tim
    Post by: Folk Hero, Jun 22, 2017 in forum: Troubleshooting
  8. Folk Hero
    Post

    Solved Can't find printer

    Now for that brilliant flash of stupidity on my part. Are you talking about windows device manager? and where in Cura is that command at? Tim
    Post by: Folk Hero, Jun 21, 2017 in forum: Troubleshooting
  9. Folk Hero
    Post

    Answered Detached wires...

    That's the one.
    Post by: Folk Hero, Jun 21, 2017 in forum: Troubleshooting
  10. Folk Hero
    Post

    Solved Can't find printer

    Windoze 8.1, Matter Control 1.5, Cura for ROBO 2.3.1, Craftware 1.14, USB 3 Tim
    Post by: Folk Hero, Jun 21, 2017 in forum: Troubleshooting
  11. Folk Hero
    Thread

    Solved Can't find printer

    I've been trying to use CURA and Craftware, but neither can find the printer. Matter Control hooks right up, but others don't find it. Tim
    Thread by: Folk Hero, Jun 20, 2017, 9 replies, in forum: Troubleshooting
  12. Folk Hero
    Thread

    Solved Matter Control and thermistor

    Since prints can take a long time I go to bed while they are printing and when I wake up the print has finished, but since Matter Control shuts...
    Thread by: Folk Hero, Jun 16, 2017, 0 replies, in forum: General Questions