1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Fred Williams II

  1. Fred Williams II
    Post

    Answered I need Power

    Thanks, I have one on the way until I get one from them as a replacement. It is the power supply as I took one out of one of the others and wired...
    Post by: Fred Williams II, Nov 27, 2017 in forum: Troubleshooting
  2. Fred Williams II
    Post

    Answered I need Power

    Thanks, found the fuse and all is in good shape....good thing I love this printer...
    Post by: Fred Williams II, Nov 27, 2017 in forum: Troubleshooting
  3. Fred Williams II
    Thread

    Answered I need Power

    OK, here is a new one for me. I have 4 of the R1+, the last arrived yesterday. I unboxed it and set it up and printed just fine. This morning,...
    Thread by: Fred Williams II, Nov 27, 2017, 5 replies, in forum: Troubleshooting
  4. Fred Williams II
    Post

    Solved Need some help, hotend loses temp and stops printing

    Mark makes some sense, but where is the temp graph in MatterControl?
    Post by: Fred Williams II, Mar 25, 2017 in forum: Troubleshooting
  5. Fred Williams II
    Post

    Solved Need some help, hotend loses temp and stops printing

    Where is the SN on the R1+?
    Post by: Fred Williams II, Mar 25, 2017 in forum: Troubleshooting
  6. Fred Williams II
    Post

    Solved Need some help, hotend loses temp and stops printing

    OK, thanks. I have changed the thermistor twice, I can't imagine they are all bad Just put in a 40W heater core per your recommendation Wires I...
    Post by: Fred Williams II, Mar 25, 2017 in forum: Troubleshooting
  7. Fred Williams II
    Post

    Solved Need some help, hotend loses temp and stops printing

    OK, installed 40W heater cartridge and still getting the error right after bed leveling....
    Post by: Fred Williams II, Mar 25, 2017 in forum: Troubleshooting
  8. Fred Williams II
    Post

    Solved Need some help, hotend loses temp and stops printing

    Yes, just the parts fan as I was adding a new fan shroud.
    Post by: Fred Williams II, Mar 20, 2017 in forum: Troubleshooting
  9. Fred Williams II
    Post

    Solved Need some help, hotend loses temp and stops printing

    I still have this issue when I have removed the fan so there is no air cooling the hot end. I will try the 40W heater and see what that gets me.
    Post by: Fred Williams II, Mar 20, 2017 in forum: Troubleshooting
  10. Fred Williams II
    Thread

    Solved Need some help, hotend loses temp and stops printing

    I have the R1+, and have been using it since December. Printing along just fine. Now I can get past the level steps as I get a hardware error...
    Thread by: Fred Williams II, Mar 20, 2017, 11 replies, in forum: Troubleshooting
  11. Fred Williams II
    Post

    Which filament is best for outdoor use?

    Formfutura ApplloX is great material to be outside and it is easy to print, like PLA.
    Post by: Fred Williams II, Jan 28, 2017 in forum: Printing Filament