1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Gary T Lindner

  1. Gary T Lindner
    Post

    Answered Autolevels but does not print

    Cleared log. Turned printer off. Turned printer on. Started print. Log attached. Looks the same as last one.
    Post by: Gary T Lindner, Jan 3, 2018 in forum: Troubleshooting
  2. Gary T Lindner
    Post

    Answered Autolevels but does not print

    Yes, MatterControl can export. Print log attached.
    Post by: Gary T Lindner, Jan 3, 2018 in forum: Troubleshooting
  3. Gary T Lindner
    Post

    Answered Autolevels but does not print

    That's at the top. I probably lost the earlier message after repeated attempts and restarting. Is there a diagnostic I can run?
    Post by: Gary T Lindner, Jan 3, 2018 in forum: Troubleshooting
  4. Gary T Lindner
    Post

    Answered Autolevels but does not print

    From GCode terminal: <-Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)...
    Post by: Gary T Lindner, Jan 3, 2018 in forum: Troubleshooting
  5. Gary T Lindner
    Post

    Answered Autolevels but does not print

    Thanks. I'll check it out later today.
    Post by: Gary T Lindner, Jan 3, 2018 in forum: Troubleshooting
  6. Gary T Lindner
    Post

    Answered Autolevels but does not print

    Thanks Mark for the quick response. I'm afraid I'm relatively new to this and do not know what you mean by the GCode terminal. Is that something...
    Post by: Gary T Lindner, Jan 3, 2018 in forum: Troubleshooting
  7. Gary T Lindner
    Thread

    Answered Autolevels but does not print

    Suddenly, when trying to print a model, the R1+ completes the 9-point autoleveling but then just freezes at the 9th point and does not print....
    Thread by: Gary T Lindner, Jan 3, 2018, 17 replies, in forum: Troubleshooting