1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by George Westwater

  1. George Westwater
    Thread

    Partial Answer Help, strange heated bed issue

    OK so something just happened to my R1+ and I am looking for some advice on what could have broken, what needs to be replaced or what in general...
    Thread by: George Westwater, Feb 6, 2018, 3 replies, in forum: Troubleshooting
  2. George Westwater
    Post

    Answered X Axis resolution issue... (Recently Showed up)

    Thank you!
    Post by: George Westwater, Apr 7, 2017 in forum: Troubleshooting
  3. George Westwater
    Post

    Answered X Axis resolution issue... (Recently Showed up)

    Glad this worked out for you. Can you link me to the bearings you bought I may need to replace mine as well (might as well after I change the lead...
    Post by: George Westwater, Apr 7, 2017 in forum: Troubleshooting
  4. George Westwater
    Post

    Answered X Axis resolution issue... (Recently Showed up)

    It could be the bearings in the carriage but I would expect it to happen more often / more erratic. Are your end stops working properly? I have...
    Post by: George Westwater, Apr 5, 2017 in forum: Troubleshooting
  5. George Westwater
    Post

    Answered X Axis resolution issue... (Recently Showed up)

    Can you post a picture of your issue? After a long fought battle we determined my was Z-Banding not layer shifting. I have new lead screws to...
    Post by: George Westwater, Apr 5, 2017 in forum: Troubleshooting
  6. George Westwater
    Thread

    Answered X Axis resolution issue... (Recently Showed up)

    Hello, everyone. I have had my Robo 3D R1 Plus for almost a year. The print quality started out great and has been great until recently. I could...
    Thread by: George Westwater, Dec 15, 2016, 10 replies, in forum: Troubleshooting
  7. George Westwater
    Post

    Question... How do I make supports easier to remove?

    Thank you Daniel. I will keep playing with the values.
    Post by: George Westwater, Feb 25, 2016 in forum: General Questions
  8. George Westwater
    Thread

    Question... How do I make supports easier to remove?

    So I have a model that I can not print without supports. it has high inner arcs and pieces the "float" a bit off the bed. So I have been printing...
    Thread by: George Westwater, Feb 25, 2016, 11 replies, in forum: General Questions
  9. George Westwater
    Thread

    Unresolved Newbie - Quality Questions.... Wispy and "Bumpy"

    Hello everyone, I recently picked up a Robo3D R1 +PLUS. So far I am having a lot of fun with it however I am running into some issues with print...
    Thread by: George Westwater, Jan 29, 2016, 3 replies, in forum: Troubleshooting