Recent Content by Howard Hail

Post

i just replaced a v2 ramps board myself and just started getting this error usually hits midway through 2nd layer do yo know which connector on...

Post by: Howard Hail, Jul 31, 2016 in forum: Troubleshooting

Post

so is excessive heat really the issue then should we add a larger fan maybe?

Post by: Howard Hail, Jun 4, 2016 in forum: Troubleshooting

Post

i would prefer just to get the board through robo3d but it is listed as sold out on website so i may have to go this way if they dont get more in

Post by: Howard Hail, Jun 4, 2016 in forum: Troubleshooting

Post

on the website it shows board is out of stock for r1 plus but in stock for r1 . I have a r1 plus so i need that board sent message but have not...

Post by: Howard Hail, Jun 4, 2016 in forum: Troubleshooting

Post

do you have a link for the R1 plus board it is listed as sold out messaged robo3d and have not heard anything back from them buying on Amazon is...

Post by: Howard Hail, Jun 4, 2016 in forum: Troubleshooting

Post

Thanks for the info it is a r1 plus I got it last August when they came out so I guess it is out of warranty hope they have the board available

Post by: Howard Hail, Jun 2, 2016 in forum: Troubleshooting

Post

Post by: Howard Hail, Jun 2, 2016 in forum: Troubleshooting

Thread

all of a sudden heated bed stopped heating any ideas ? can software be overridden to still print

Thread by: Howard Hail, Jun 2, 2016, 9 replies, in forum: Troubleshooting