1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
jim3Dbot
Joined:
Jun 1, 2015
Messages:
246
Likes Received:
124
Trophy Points:
43
Gender:
Male
Birthday:
March 8
Location:
Pymatuning Lake, PA
Occupation:
Electronic Prototyping & Design

Share This Page

jim3Dbot

Active Member, Male, from Pymatuning Lake, PA

3D Rookie, electric-roundup on Ebay Jun 14, 2015

    1. grant
      grant
      Could you help me with my robo r1 IR sensor install? Thank you !
      Jan 19, 2019
    2. jim3Dbot
      jim3Dbot
      3D Rookie, electric-roundup on Ebay
      Jun 14, 2015
  • Loading...

  • About

    Gender:
    Male
    Birthday:
    March 8
    Location:
    Pymatuning Lake, PA
    Occupation:
    Electronic Prototyping & Design
    Designer Of PCB's, Thru-hole, multi-layer, aluminum, & SMT. Prototype & dedicated test fixture design.

    Purchased Robo3D R1 March of 2015. No experience prior with 3D printing. However, own CNC router with a 2' x 3' table.

    Knowledge obtained by this great forum, u-tube, & Matter Control sites.

    Purchased printer, ran about a 1/2 dozen prints....worked great right 'outta the box'......contrary to other reports I have read. Downloaded 123Design, Sketch up, Design Spark. Settled with Design Spark. Designs cleaned-up in Mesh mixer, then to Matter control, (have not tried Cura yet).

    After owning the printer for slightly over a month, I totally disassembled for S & Giggles. Installed a E3D v6 hot end, as per Mikes excellent instructions, printed spool holder, printed print fan holder, and modified z limit switches with LED indicators for X truing.

    Thanks guys for an excellent site....Jimmy

    Interact

    Content: