1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Josh Donesky

  1. Josh Donesky
    Post

    Z Axis no homing after changing board out to a Big Tree Tech skr 1.3 Board.

    Some pictures of the board wiring
    Post by: Josh Donesky, Sep 3, 2019 in forum: Projects
  2. Josh Donesky
    Post

    Z Axis no homing after changing board out to a Big Tree Tech skr 1.3 Board.

    What firmware do I need?
    Post by: Josh Donesky, Sep 3, 2019 in forum: Projects
  3. Josh Donesky
    Post

    Z Axis no homing after changing board out to a Big Tree Tech skr 1.3 Board.

    Here is an error message I got when trying to print
    Post by: Josh Donesky, Sep 3, 2019 in forum: Projects
  4. Josh Donesky
    Post

    Z Axis no homing after changing board out to a Big Tree Tech skr 1.3 Board.

    Thank you for your response! Like I said, I am very knew at all of this. I wasn't actually the one who installed the new board. I bought it from...
    Post by: Josh Donesky, Sep 3, 2019 in forum: Projects
  5. Josh Donesky
    Post

    Answered Z Homing Issue on newly updated R1+

    Was the solution ever found? I am having the same issue!!!!
    Post by: Josh Donesky, Sep 2, 2019 in forum: Troubleshooting
  6. Josh Donesky
    Thread

    Z Axis no homing after changing board out to a Big Tree Tech skr 1.3 Board.

    I just got this printer and upgraded the board to a Big Tree Tech SKR 1.3, but the dual z movement is screwy. I'm new to this, and not very savvy...
    Thread by: Josh Donesky, Sep 2, 2019, 11 replies, in forum: Projects