1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by JuanPinto

  1. JuanPinto
    Post

    Unanswered Z rod bent- Banding

    Hey guys, I was able to get a replacement in no time from the manufacturer, and for the most it looks pretty good, i am still noticing some very...
    Post by: JuanPinto, Feb 14, 2016 in forum: Troubleshooting
  2. JuanPinto
    Thread

    Unanswered Z rod bent- Banding

    Hey guys, I am getting bad Z banding/ribbing on my prints Robo +plus, no mods besides LCD. What is the best way to fix this? Do I need new Z...
    Thread by: JuanPinto, Feb 5, 2016, 4 replies, in forum: Troubleshooting
  3. JuanPinto
    Post

    Solved Extruder stepper motor Stuck

    Thanks guys!
    Post by: JuanPinto, Jan 31, 2016 in forum: Troubleshooting
  4. JuanPinto
    Post

    Solved Extruder stepper motor Stuck

    Definitely under warranty, I have removed all the filament from the extruder and disabled all the stepper motors and at that point the gears turn...
    Post by: JuanPinto, Jan 30, 2016 in forum: Troubleshooting
  5. JuanPinto
    Thread

    Solved Extruder stepper motor Stuck

    Info. Robo 3D R1 Plus (new model) XXL LCD Screen No jam or clog All wires properly connected Stepper motor for the extruder is skipping, two...
    Thread by: JuanPinto, Jan 30, 2016, 9 replies, in forum: Troubleshooting
  6. JuanPinto
    Post

    err: TEMP FALL ERROR

    Hey guys, I believe I am running into the same issue. Can anyone point me in the direction to reattach the thermistor properly? What adhesive did...
    Post by: JuanPinto, Jan 30, 2016 in forum: Troubleshooting