1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Kotaztrafee

  1. Kotaztrafee
    Post

    Answered Flow Cube a Mess, Model a Mess

    Replaced the X belt. The original belt was stretched and the adjustment was at max. I now have a tighter belt. I ran the lower portion of the...
    Post by: Kotaztrafee, Jun 14, 2023 in forum: Troubleshooting
  2. Kotaztrafee
    Post

    Answered Flow Cube a Mess, Model a Mess

    OK, SO, I printed the lower portion of my model with a finer mesh and it helped a lot. I can still see concerns but I think that is because of...
    Post by: Kotaztrafee, Jun 12, 2023 in forum: Troubleshooting
  3. Kotaztrafee
    Post

    Answered Flow Cube a Mess, Model a Mess

    Thanks again for your reply. I am currently investigating that it is my file. Around the same time that everything seemed to be going wrong I...
    Post by: Kotaztrafee, Jun 12, 2023 in forum: Troubleshooting
  4. Kotaztrafee
    Post

    Answered Flow Cube a Mess, Model a Mess

    Thanks for taking the time to reply with the links. Of all the issues I feel like over extrusion matches the best. I have adjusted the flow from...
    Post by: Kotaztrafee, Jun 12, 2023 in forum: Troubleshooting
  5. Kotaztrafee
    Thread

    Answered Flow Cube a Mess, Model a Mess

    Hello everyone,I print with ASA and have very little problems other than ringing which I cleared up but now have this miserable condition that I...
    Thread by: Kotaztrafee, Jun 12, 2023, 10 replies, in forum: Troubleshooting